The future of roof sheet rolling machine needs to focus on breakthroughs in several aspects:
First, keep up with international quality standards and develop independent and innovative process designs. It will develop in the direction of fully automated production standards.
Second, under the condition of ensuring the speed and accuracy, to develop a multi-type roof sheet rolling machine, which can not only produce high-precision and low-error roof panels, but also change models to produce high-strength wall panels. It is used to decorate the roofs of industrial park buildings, factory buildings, logistics warehouse, and private residential house.
Daily maintenance of roof sheet rolling machine
1. When changing lubricating oil every month. The filter should be replaced or cleaned as appropriate.
2. The air filter on the fuel tank. It is also inspected and cleaned every 3 months.
3. If the machine has daily run noises, when the sound is louder than usual, it is necessary to check the oil quality and other problems in time.
4. It is very important to pay attention to clean hydraulic components every month. Prevent the fine granular objects in the factory from causing unnecessary scratches and abrasion inside the machine.
5. Before feeding the roof sheet forming machine, the positioning plate should be adjusted in time to correspond to the width of the material roll and the feeding equipment. When the material roll is brought from the guide roller to the guide frame, it is smoothed by the guide roller, and then enters the rollers of the roller assembly. Each forming process of the material roll is designed, and cold bending is carried out with corresponding strength. The post-cutting is used to cut and cut the formed plates, and then complete the production process of the plates.
6. Pay more attention to the oil level in the fuel tank during monthly machine inspections. If there is a partial failure of the hydraulic system, it must also be checked twice. Completely repair the source of the fault of the roof sheet forming machine, which can avoid the same fault situation from happening again.
7. After the new equipment is put into production about a month or so, it is necessary to carry out a corresponding debugging and inspection of each component. Focus on checking the application of the roof sheet forming machine without any deformation, distortion, or damage of the components. If there is any abnormality, it should be replace and repaired in time.