When there is a need to adjust the roof tile forming machine, the power supply must be cut off first. Pay more attention to the safety of your hands when inspecting and repairing the moving parts of each part of the roof tile forming machine.
Before starting to operate the equipment, be sure to observe whether the connections of the various components of the equipment are tight. Whether the nuts and nuts are loose or not locked. And before starting the machine for trial operation, add enough lubricating oil.
When starting up and running, observe the part of the roller rolling assembly to see if there is any abnormal vibration card, noise and whether the movement of each part is coordinated. Only after all parts are normal, can the plate be produced in batches. In the process of high-speed production and operation of the roof tile forming machine, if any irregular equipment is found, the operator must immediately cut off the power supply and shut down for inspection.
In addition, the following also summarizes the points that need to be paid attention to during the use of the 4-point device. I hope it will be helpful to you.
1. The roof tile forming machine must be equipped with an electronic control system with high digital pulse input function for corresponding use.
2. The detection part of the electric control system of the roof tile forming machine: detecting the pulse encoder, the up and down running program switch, the up and down running program button, the emergency stop standby switch, the hydraulic start and stop switch, etc.
The rotating parts of the machine tool roller assembly should be regularly lubricated. The operator should add lubricating oil once a week. The mechanics add lubricating oil to the rotating bearing part every six months, which can better ensure the long-term non-destructive application of the roof tile forming machine.