The solar photovoltaic bracket is produced by Solar Post Roll Forming Machine, which is a special bracket designed for placing, installing and fixing solar panels in the solar photovoltaic power generation system. The general materials are aluminum alloy, carbon steel and stainless steel.
The related products of the solar support system are made of carbon steel and stainless steel. The surface of the carbon steel is hot-dip galvanized, and it will not rust for 30 years when used outdoors.
The solar photovoltaic mounting system is characterized by no welding, no drilling, 100% adjustable and 100% reusable.
The origin of solar photovoltaic support:
The global energy crisis has promoted the rapid development of the new energy industry. Solar energy is the most important basic energy among all kinds of renewable energy.
Therefore, as a solar power generation technology that converts solar radiation energy into electrical energy, the photovoltaic industry is developing rapidly;
In the old concept, the photovoltaic industry mainly includes the production chain of solar modules, and the production chain of electrical control components such as control devices and inverters.
The application advantages of solar support systems in solar panel support go far beyond simple production and installation. The solar panels can also move flexibly according to the sun's rays and seasons.
Just like when it was just installed, the slope of each solar panel can be adjusted by moving the fasteners, adjusting the slope to suit different angles of light, and tightening again to make the solar panel exactly fixed in the designated position.
n order to obtain the maximum power output of the entire photovoltaic power generation system, the solar modules are oriented in a certain direction according to the geography, climate and solar resource conditions of the construction site.
The supporting structure with fixed arrangement and spacing, usually steel structure and aluminum alloy structure, or a combination of the two.
Main Parameter Reference:
Installation location: building roof or curtain wall and ground
Installation orientation: it should be south (except for the tracking system)
Installation angle: equal to or close to the local latitude of installation
Load requirements: wind load, snow load, seismic requirements
Arrangement and spacing: combined with local sunshine conditions
Quality requirements: no rust for 10 years, no reduction in rigidity for 20 years, and certain structural stability for 25 years.