Ceiling T Bar is a specially shaped keel structure used in construction or engineering. It is usually used in ceiling or wall support systems. It has a T-shaped cross-section, i.e. a horizontal beam at the top of the keel, which provides better support and structural stability. This design can effectively distribute the loads and increase the strength and stability of the structure, as well as facilitate installation and maintenance.
Ceiling T Grid are common ceiling support structures used to support ceiling panels such as gypsum boards and aluminum panels. They provide good load bearing capacity and stability and are suitable for various building types such as residential, commercial buildings, hospitals, etc. T-bar are also used to support partition panels, such as gypsum board or wood panels, in lightweight or non-load-bearing wall constructions. This structure can effectively share the load of the wall and is easy to install.
The production process of T-Bar is to have galvanized steel and other raw materials through the Ceiling T Bar Roll Forming Machine, for forming, punching and cutting and other processes.
About Ceiling T Bar
Features of Ceiling T Grid
1. High flatness, bright color, strong sense of metal.
2. Not easy to deform and fall off, long service life.
3. Simple process, short working period.
4. Many styles and colors, can be customized upon request.
5. No radiation, environmental protection.
6. No safety hazards, such as: moisture deformation, insect, shedding and other phenomena.
01
Installation of ceiling t grid
Preparation
1. Make the positioning ruler: the positioning ruler is 1-24mm long; 4-5mm wide; wooden and iron can be used.
2. Clean up the wall base: remove the cement floating block; check the straightness of the wall, the gap is not more than 3 mm.
02
Installation of clips
1. Cement nail fixing: cement nail length 32 mm; snap spacing is about 4 mm; wall end about 3 mm a.
2. Impact drill hole fixing: Drill holes into the wall with an impact drill; fix the clips.
3. Instructions: Use carpentry nail gun or self-tapping screws to fix the clips.
03
Ceiling T Bar System installation steps
1. After the snap installation on the same straight line, cut the yin and yang corners, tear open the kick protection film, sealing.
2. Gradually press in from one end to the other, do not hammer.
3. After installation, seal with silicone.
4. Tear off the kick protection film.
5. Use AB glue to stick the corner, corner and header in the joint.
04
Precautions for T Grid installation
1. The articulation gap should be less than 3mm.
2. Shovel the wall first to avoid paint sticking to the surface of the skirting.
If you want to know more about Ceiling T Bar products or what's on the machine, feel free to contact KINGREAL!