Regularly clean
Take out the dust of the shelf with clean dishcloth, remember to clean the shelf had better avoid clear water, because rinse the shelf with water easily causes the surface oxidation of the shelf, shorten the service life of the shelf.
Orderly shelf arrangement
Put the tools, accessories and workpieces (products) neatly on the shelves. The pipes and lines shall not be stacked up and block the passage.
Special weather maintenance
If the shelf in wet days maintenance method:
1. The warehouse should not open doors and Windows as much as possible, which is conducive to reduce the outside moist air into the room, reduce the possibility of shelves damp.
2. If possible, open the dehumidifier to protect the warehouse from moisture. Or put some desiccant in the warehouse.
3. The shelves need to be cleaned with a rag after being dampened to avoid shelf rust, especially the interface location of the shelves, where it is easy to rust.
The shelves are inspected once a week
1. Check the use of the shelf and follow the use principle of the shelf
A. The use of cow power shelf should prevent top-heavy goods: the principle of light goods on the top and heavy goods on the bottom should be followed.
B. Use to prevent overload: the weight of each layer of goods stored shall not exceed the maximum shelf load designed. C. Super high width should be avoided: the shelf height and floor width have been limited, and the size of the card board and goods should be slightly less than 100mm of the net space.
D. The shelf should be impact-proof: the forklift should be handled and handled as lightly as possible during operation.
E. When goods are placed on the upper shelf, operators should try not to go directly to the bottom of the shelf.
F. Use of shelves should prevent the use of non-standard floor plates (card plates) on the shelves, chuan Zi bottom is the most suitable.
2. Check the size and type of all stored goods;
3. Check whether the configuration of appearance is consistent with the original reality;
4. Check the deformation of the shelf;
5. Check whether the safety pin is complete and damaged; F. Check whether the beam, gear and accessories are damaged, and correct the straightness of the column;
6. Check the weight of pallets;
7. Check whether the ground expansion bolts fixing the column are loose;
8. Check foot pads and other protective measures;
9. Check whether the ground is sinking or damaged;
10. Inspectors shall record truthfully according to the actual situation, submit written inspection results to the department head, and dispatch professional shelf personnel to eliminate hidden dangers.