To install the ceiling channels, which is produced by Metal Ceiling Carrier Making Machine you need to stretch the wire to fix the hanging rod. After installing the main bar, install the vice bar and cover panel to avoid bending. It should be noted that the connection must be firm, and there should be no peeling and degumming.
The following will introduce you to the detailed content.
There are 6 steps to install the ceiling channels:
1. Before installing the light gauge steel, the spring line is to be used to pop up the level line on each corner of the room with a level. This method of springing thread is often used in home decoration.
6. When installing the cover panel, it should be noted that the panel should avoid bulging, bending, etc., if it occurs, it should be dealt with in time.
Precautions for ceiling channels:
1. For wooden suspended ceilings, the wooden keel must be free of scars, and the suspenders must be firmly connected to the wooden keel and floor slab. The frames should be painted with fire-resistant and corrosion-resistant paint. The cover panel of the entire suspended ceiling should be flat and free of angles, peeling, and degumming.
2. For light gauge steel, which is produced by light gauge steel machine is necessary to ensure that the positions of the keels, booms, and connectors are correct, the materials are flat and straight, the links are firm, and there is no looseness.
3. The distance between the boom and the end of the main bar should not exceed 30 cm, and the center of the ceiling channels should be from the short side is arched 1/200.
4. For the plastic gusset ceiling, the splicing should be neat and straight, without chromatic aberration, deformation and stains. Panels, lamps, walls, etc. should be tight, no leaks, and light lamps and ventilation fans should be tightly connected to the frames.