The photovoltaic racking cold bending forming machine is a very important equipment, which can be used to make photovoltaic racking suitable for solar panel installation by cold bending and molding metal sheets of different materials. Therefore, in the photovoltaic industry, the photovoltaic racking cold bending molding machine is widely used and has become an indispensable and key tool in the industry.
1. Pre-preparation
Before the cold bending forming of photovoltaic stents, a series of preliminary preparations are required. First of all, the cold-formed molding machine for photovoltaic stents to check and maintain to ensure the normal operation of the equipment. Secondly, we need to prepare the raw materials for photovoltaic stents, cold-formed molding before the raw materials should be pre-treated, including de-oiled, de-rusted and other treatments.
2. Edge grinding treatment
After the cutting is completed, the cutting end face needs to be trimmed. Edge trimming can make the cut of the plate become flat and more beautiful. At the same time, after grinding the end face, it is easier to connect.
3. Positioning
In the Solar Strut Channel Forming operation, you need to fix and position the material. Fixing and positioning is the key to protect the accuracy of cold roll forming, so special attention is needed. Fixed to ensure that the verticality and flatness of the material, positioning accuracy also needs to be ensured.
4. Mold adjustment
Cold roll forming machine molding requires the use of different molds. Before the molding needs to ensure that the mold and equipment to match the problem. When adjusting the mold, should be adjusted and modified according to the actual situation.
5. Roll forming process
When the roll forming machine preparatory work and mold adjustment work is completed, you can carry out the molding of the photovoltaic support work. In the molding process, always pay attention to whether the plate has deformation, fracture and other phenomena, and observe the molding effect.
6. Post-processing
In most cases, the photovoltaic support cold-formed molding process will produce some irregular shapes. Therefore, after the molding is completed, the need for post-processing of photovoltaic mounts. Including cutting, grinding, wiping and cleaning steps, which can ensure the beauty and safety of the photovoltaic bracket.