Before applying the cold roll forming machine, the common problems should be prepared very well in advance. Here is a brief introduction. What are the key points of general attention?
First, before application, be sure to choose a leveled cabinet countertop for placement to ensure that the equipment is stable. Then open the feet of the main box to facilitate observation. Then insert the power plug into the control panel and turn it tightly. Secondly, one end of the power plug is plugged into the control panel at the back of the main box, and the other end is plugged into the switching power supply, and it is stipulated that a single-phase three-wire switching power supply is generally used.
Then turn on the power switch behind the main box, and carry out the actual operation according to a certain method, and adjust it to a certain value.
Later, until the emerald green indicator light is turned on and the reminder sound appears, the next work is the sealing work, and then the quality of the sealing is checked, and the actual operation is carried out according to different materials to ensure the sealing. The quality is guaranteed to be the best.
Mandatory maintenance of the cold roll forming machine is very important:
The excellent maintenance of all industrial equipment is an important step to increase the service life. From the perspective of the entire application cycle time of the cold roll forming machine, application, maintenance and overhaul account for the vast majority of the total service life of the cold roll forming machine. This guarantees that the cold roll forming machine can give full play to its practical value.
The cold roll forming machine project has a large construction volume list, complicated daily tasks, high project investment, fast schedule and strong periodicity, and mandatory maintenance of the cold roll forming machine is necessary. Mandatory maintenance is very important for long-term field operations and equipment in difficult environments. According to the common failure analysis, 56% of the cold roll forming machines are based on difficult maintenance caused by fear of maintenance, 38% are due to on-time maintenance errors, and 6% are caused by incorrect operations. Therefore, mandatory maintenance is cold the bending machine is necessary.
Why should the cold-drawn forming equipment do a good job of lubricating:
Lubrication can be intermittent and sustainable in terms of time. In terms of daily maintenance, if the equipment does not operate, you only need to change the oil once more than half a year, but if the equipment is in operation, the second and the third lubrication time period should be in the middle of twenty to thirty days.
The time is good and there is no need for long intervals. When the equipment is running, you should pay attention to whether the oil injector is out of oil when the main shaft bearing is running. In case of common faults, the maintenance should be terminated immediately. And if the fuel tank of the car is not cleaned and tidy, other oil or re-oil cannot be used to prevent damage to the rolling bearing.
All in all, the operation of the device is carried out by the mutual cooperation of several components. Therefore, doing a good job of normal lubrication is also to better make the cold-drawn forming equipment operate more strongly, so as to improve the work efficiency.