Usually, the test run of the Cable Tray forming machine is for the sake of the normal operation of the equipment. The Cable Tray forming machine is tested for a certain period of time under no-load condition, and it can continue to work if there is no abnormal situation within this certain period of time.
If there is no link to test the machine and work directly, then abnormal conditions will severely damage the equipment and may bring certain risks to the operator. The test time is usually a few minutes, not very long. It will not bring much loss to the progress of the project, so the test machine before the work of the Cable Tray Forming Machine is important.
Next are the precautions for debugging the Cable Tray Forming Machine, hoping to help you.
1. Test and check the balance cylinder action status of the Cable Tray Forming Machine and its oil lubrication system oil circuit, joint, etc.
2. The friction between the slider and the guide rail of the Cable Tray Forming Machine is relatively frequent. Necessary adjustments should be made to correct it, and the lubrication and pipelines of the joints should be checked to ensure good operation.
3. Regularly lubricate the gear parts of the Cable Tray Forming Machine: the gear transmission box and the internal parts are more likely to be damaged due to frequent operation, and the possibility of loosening is more likely.